Watlow D4T Data Logger
•
49
•
Chapter 3 Using the D4T Front Panel
Note:
All closed data log files are transferred. If a file is open during the logging process, that
file will not transfer until closed.
To transfer files manually:
1. Push the
Menu button.
2. Push the
File Transfer button.
Note:
The graphic above may or may not look similar when viewed on your D4T. To appear as
shown, a USB thumb drive must be installed and both a TFTP and Samba server must be
configured.
3. Push the
Export button for the desired destination.
To transfer files automatically:
1. Push the
Menu button.
2. Push the
Data Logging button.
3. Push the
Data Log File Transfer button.
4. Select Auto Transfer Type,
TFTP, Samba or USB.
If TFTP or Samba is selected above, the server must be configured. For instructions on how to
configure either or both, click on the server of choice:
or
Flashing the Data Logger Firmware
On occasion, the D4T firmware may be updated. When flashing the firmware ensure that pow-
er to the data logger is not disrupted and allow the process to proceed to completion. Once
the process is complete, the data logger will come back up with the same configuration (in its
entirety) prior to flashing.
To flash the data logger to the latest firmware version:
1. Copy the file "D4TUpdate" to the root directory of a USB thumb drive.
2. Insert the USB thumb drive into either of the USB ports on the back of the D4T.
Note:
Prior to initiating this process ensure that there is only one thumb drive connected.
3. Push the
Menu button.
4. Push the
Settings button.
5. Push the
Update button.
6. Push the
Install Update button.
