3
3.1 Power ON/OFF.
Press and hold M for a few seconds to turn both the display and the controller on or off. When the
power is off, the display no longer consumes power.
The bike will automatically turn off if not used for 10 minutes.
3.2 Selecting Mode
When the display is turned on, the default mode is Current Speed. Pressing M cycles through the
other modes in the order: Current Speed →
TRIP
→ ODO. If the current speed exceeds 0 km / h, the
mode returns to Current Speed after 2 seconds.
Resetting TRIP mode is done as follows: press the M button until you get to TRIP, then hold down the
M and DOWN for 5 seconds. TRIP resets automatically.
3.3 Rear light
Press and hold UP briefly to turn the tail light on/off.
3.4 PUSH Assistant
Press and hold DOWN to enter push assist mode. The motor causes the bike to drive 6 km / h.
3.5 Support level
Press UP and DOWN to change the support level and change the output power of the motor. The
range of support level is 1-5.
Level 1 is the lowest and level 5 is the highest. The standard level is level 1.
Summary of Contents for Brooklyn
Page 1: ...1 Manual WATT Brooklyn...
