10
Need help or have any questions? Call us at 1-714-963-0329 or send us an email to service@globalhobby.net
❑
Carefully adjust the three control trim tabs on the
transmitter so that they are centered, as shown.
The horizontal trim tab below the throttle
control stick is not used in this application.
PRO TIP
❑
Looking from the back of the airplane, push the
right-hand control stick completely to the left. The vertical
control surface (rudder) should move left.
❑
Again looking from the back of the airplane, push the
right-hand control stick completely to the right. The
rudder should move right.
If the rudder
does not move in the
correct direction, flip the
CH 2 servo reversing
switch on the transmitter,
as shown.
❑
Looking from the back of the airplane, pull the
right-hand control stick completely back. The horizontal
control surface (elevator) should move up.
❑
Again, looking from the back of the airplane, push the
right-hand control stick completely forward. The elevator
should move down.
If the elevator
does not move in the
correct direction, flip the
CH 1 servo reversing
switch on the transmitter,
as shown.
PRO TIP
PRO TIP
❑
If the control surfaces are not exactly even with the
tail, use your fingers to carefully bend open or closed the
U-shaped bend in the pushrod wire until the back edge of
each control surface is even with the tail.
