6
Need help or have any questions? Call us at 1-714-963-0329 or send us an email to service@globalhobby.net
❑
Remove the battery cover from the back of the
transmitter by pulling down on it with one hand while
holding the transmitter with your other hand.
SECTION 4: ASSEMBLING YOUR CESSNA 180 EP RTF
❑
Install 8 fresh AA Alkaline batteries, being careful to
make sure that the polarity is correct for each battery.
If you use rechargeable AA NiCD cells,
double-check to make sure that they are fully charged
before installing them into the transmitter.
Never
attempt to charge or recharge Alkaline cells.
❑
After double-checking that the batteries are installed
correctly, reinstall the battery cover, making sure it's firmly
seated into place.
PRO TIP
Step 1: Installing the Transmitter Batteries
Step 2: Installing the Vertical Tail Surface
❑
Carefully push the vertical tail down into the top of the
fuselage, making sure that the base of the vertical tail fits
firmly in the molded slot .
❑
While holding the vertical tail surface down firmly,
carefully thread one screw into the hole in the side of the
mounting tab, to secure the vertical tail surface into place.
Install the screw from the left side of the
vertical tail surface, as shown. The screw will thread
easily through the foam material and into the other side
of the mounting tab. Do not overtighten the screw.
PRO TIP
