26
Need help or have any questions? Call us at 1-714-963-0329 or send us an email to service@globalhobby.net
YOU'LL NEED THE FOLLOWING PARTS:
❑
{2} Rubber Bands
SECTION 8: WING MOUNTING
YOU'LL NEED THE FOLLOWING SUPPLIES:
Step 1: Trimming the Wing Mount
❑
Using a pair of scissors, carefully cut out the base of the
plastic wing mount leaving about 1/8" of material beyond
the radius.
❑
Scissors
❑
220 Grit Sandpaper w/Sanding Block
❑
Using a pair of scissors, carefully cut away and remove
the plastic from over the two molded pushrod exit slots in the
back of the wing mount.
❑
Using 220 grit sandpaper with a sanding block, sand the edges of the plastic wing mount smooth and straight.
Step 2: Mounting the Wing
❑
Set the wing assembly onto the fuselage. To align it properly, the front of the wing mount should be pushed up
against the back of the gear box and centered on the fuselage.
IMPORTANT
Depending on the positions of the elevator and rudder pushrods, you may need to enlarge the slots in the back of the wing
mount to clear them. You may also need to cut the servo arms shorter so they don't hit the sides of the wing mount.
