pg.8
WB-UPS-1100/1500/2000 Owner’s Manual
LCD MENU SETUP (UPS OFF IN STANDBY)
Using the Menu
Action
Instructions
Enter Setup
With the UPS powered off in Standby mode, press and hold SELECT for three seconds to enter Setup.
Menu Navigation
Press ON/MUTE and SELECT to toggle between setup modes 1-7.
Change Setting
Press OFF/ENTER to configure the current setting on the screen.
Use ON/MUTE and SELECT to toggle the setting value.
Press OFF/ENTER again to save the setting and return to the menu.
Menu Options
Screen
Instructions
01 Output Voltage
Set the output voltage for the UPS outlets in both power and battery mode. Options:
110V AC
115V AC
120V AC (Default)
127V AC
02 Programmable Outlet Enable
Set the programmable outlet function. Options:
ENA: Enable the programmable outlets to turn off after a set amount of time in battery mode. Use the
next menu setting below to select how long the programmable outlets remain on. (Default)
DIS: Disable the programmable outlet function. Using this setting, all UPS outlets will remain on battery
mode until the battery is depleted.
03 Programmable Outlet Timer
This setting is used only when the programmable outlets are enabled. Use the buttons to set the numbers
of minutes for the programmable outlets to remain on when the UPS switches to battery mode.
Options:
1-999: Number of minutes.
06 Battery Backup Time Limit
Set the amount of time that nonprogrammable outlets remain on while in battery backup mode. Options:
0-999: Set the backup time in minutes from 0-999 for uncontrolled outlets on battery mode.
DIS: Disable the feature. Backup time will depend on battery level. (Default)
Note: When set to “0” the backup time will be ten seconds.
07 Battery Total Amp Hours
Set up the battery total amp hours of the UPS. Options:
7-999: Setting the battery total capacity from 7-999 in AH. Be sure to set the correct battery total
capacity if an external battery bank is connected.
00 Exit Setup
Press OFF/ENTER to exit the Setup menu.
