WATTBRICKS MP330, User Manual

www.wattbricks.com 

13

Q: My AC device is rated for less than the rated wattage of the product, but my device won't turn 

on when plugged into the AC port.

A: Certain devices require more wattage upon startup than may be listed on the device

.

If

the

startup

wattage

of

the

device

exceeds

the

rated

/

continuous

wattage

of

the

product, 

the

device

will

not

turn

on, even

if

the

wattage

listed

on

the

device

is

less

than

listed

on

the

product. In

this

case, verify

the

AC

port

is

working

by

trying

a

lower

wattage

device

TROUBLE SHOOTING

The device does not discharge: 

(1) Check whether the output buttons are activated ; 
(2) Check whether the total output power exceeds the rated output power; 
(3) Check whether the temperature of the equipment is too high. 

The device can not be charged: 

3)  If the device cannot be charged immediately after it is discharged, please wait for an hour 

and try again, it may enter the over-temperature protection.

1

）

Confirm that the wall plug power adapter's cord is inserted fully into the DC Input.

2

）

Confirm that the AC wall plug power adapter is the charger provided with MP500.If the input 

does not comply with the requirements located in the general specifications section, the low 
watt range 0 % to 10 %may be displayed on the LCD.

In the event that the unit catches fire:

Never attempt to extinguish a fire if it is unsafe to do so. Contact your local fire department. If it 
is safe to do so use an electronic safe fire extinguisher or fire blanket. Do not touch any hot or 
burnt components. Dispose of the unit only when safe to do so after the unit is extinguished and 
fully cooled. 

Getting

the

Battery

Pack

Wet

.

Warning: Getting

your

battery

pack

wet

could

cause

electric

shock

or

other

bodily

harm

. 

Never

attempt

to

power

on

a

wet

battery

pack

. 

Surface

Water: 

IF

your

battery

pack

was

lightly

splashed

with

water

, 

wipe

the

unit

dry

and

allow

it

to

fully

dry

For

several

hours

before

powering

on

.

Water

got

inside:  

IF

water

entered

the

battery

pack

, 

do

not

touch

the

battery

pack

and

place

it

in

a

safe

area

until

Fully

dry

. 

Do

not

attempt

to

power

the

battery

pack

on

and

dispose

of

the

battery

pack

in

accordance

with

local

laws

.

Battery

fell

into

water:

Do

not

attempt

to

retrieve

the

battery

back

, 

and

contact

your

local

fire

department

for

guidance

. 

If

unit

is

retrieved

from

the

water

, 

do

not

touch

the

battery

pack

and

place

it

in

a

safe

area

until

fully

dry

and

dispose

of

it

properly

in

accordance

with

proper

battery

disposal

.

NOT

WATERPROOF

NOT

FIREPROOF