12
ISOMIX HC-IM-DE-W-DE-10-2018-Rev1_enUS | Art. No. 10070436
EN
ENGLISH
8 Maintenance
Electrical energy!
Perform maintenance work on the Isomix
only when the power supply has been
disconnected.
Hot water!
Risk of severe scalding.
Do not reach into the hot water when
emptying the Isomix.
Ensure that the Isomix has cooled
down before carrying out maintenance,
cleaning and repair work.
Hot surfaces!
Risk of serious burns.
Do not touch the pipes or components
during operation.
Ensure that the Isomix has cooled
down before carrying out maintenance,
cleaning and repair work.
Wear heat-resistant safety gloves if it
is necessary to carry out work on hot
components.
Maintenance of the Isomix-HC must be
carried out only by trained personnel
who have been authorized by the
manufacturer.
8.1 Annual maintenance
1. General visual inspection
• Check the control station for leaks and retighten sealing
connections or replace seals, as required.
2. Functional check
• Check that settings and operating and performance
parameters are set correctly.
• Check flow noise during operation.
• Ask users if there are any noticeable problems.
3. Action to be taken following maintenance work
• Check that all screw fittings that were unscrewed have
been retightened and retighten if necessary.
• Remove all tools, materials and other equipment used from
the working area.
• Restore the power supply.
• Slowly pressurize the Isomix and vent it.
• Readjust the system settings if required.
8.2 Replacement of wear parts
Please note that the Isomix contains parts that, for technical
reasons, are subject to wear depending on the intensity of
use, even if the specified care and maintenance has been
provided.
This applies especially to mechanical parts and parts that
come into contact with water and steam, such as hoses,
seals, valves, etc.
By their nature, defects caused by wear do not constitute a
fault and are therefore not covered by the warranty or any
guarantee. Nevertheless, these defects and malfunctions
must be remedied by trained specialist personnel only.
Contact your specialist dealer for this.