Page 10
Black Tube Connection
Measure the black tube from faucet to the black drain
saddle and make a straight cut with a sharp knife
though tube.
Remove black plastic nut from drain saddle. Slip black tube
through black nut. Insert black tube into the opening in the
drain saddle and tighten the black nut securely.
This is a gravity fed line, if there is any bend in the tube the
rinse water will not flow into the drain properly. Water will back
up and come out the air gap hole in the back of the faucet
base.
The tubing must be as SHORT and STRAIGHT as possible, making a downward slope from
faucet to drain saddle to allowfor proper drainage.
Step 25
Note:
Step 26
Step 27
Red Tube Connection
Using the white plastic union in the parts bag, determine where
the red tubing from the faucet and the black tubing from the RO
membrane housing would join together comfortably. Cut the
tubes leaving a straight cut on both tubes. Insert the red tube in
one end of the white plastic union and the black tube in the other
end. Use a 5/8" wrench to tighten both of the white plastic nuts
securely.
Gather the pieces needed for the Final Filter installation. Each
unit is supplied with a final filter and 2 white plastic connectors.
Remove the blue caps from the final filter.
6” Final Filter Installation
Step 28
Note:
Step 24
Summary of Contents for 5 SV DELUXE
Page 19: ...Page 19 California Certification...
Page 24: ...Page 24...
