Watts Premier 5 SV DELUXE Installation, Operation And Maintenance Manual Download

Page: 20 / 28

Page 20

RECOMMENDED REPLACEMENT PARTS AND CHANGE INTERVALS:
Note: Depending on incoming feed water conditions replacement time frame may vary.

Description

Change time Frame

Price

Sediment Pre-filter: #5m-10

6 Months

$4.50

Carbon Pre-filter:

#GAC-410-56/#5MCB

6 Months

$9.00/10.50

Final Carbon filter

#1m-6/#1M-10

12 Months

$9.00/11.95

R.O. Membrane:

#TFM-24

2 to 5 years

$82.95

This system has been tested according to NSF/ANSI 58 for reduction of the substances below. The concentration of the indicated substances in water
entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system as specified in NSF/ANSI 58.
This system has been tested for the treatment of water containing pentavalent arsenic (also known as As (V), As (+5), or arsenate) at concentrations
of 0.30 mg/L or less. This system reduces pentavalent arsenic, but may not remove other forms of arsenic. This system is to be used on water
supplies containing a detectable free chlorine residual at the system inlet or on water supplies that have been demonstrated to contain only pentavalent
arsenic. Treatment with chloramine (combined chlorine) is not sufficient to ensure complete conversion of trivalent arsenic to pentavalent arsenic,
Please see the Arsenic Facts section of the Performance Data Sheet for further information.

Avg. In.

Avg. Eff.

% Reduction pH

P r e s s u r e

Max Eff.

Inf. challenge

Max Allowable

concentration

mg/L

Arsenic (Pentavalent) 334.615 ug/L

5.0385 ug/L

98.4%

50psi

19 ug/L

0.30±10%

0.010 mg/L

Barium Reduction

10.2 mg/L

0.207 mg/L

97.9%

7.24

50psi

0.3 mg/L

10.0±10%

2.0

Cadmium Reduction

0.036 mg/L

0.0005 mg/L

98.6%

7.49

50psi

0.0007

0.03±10%

0005

Chromium (Hexavalent) 0.15 mg/L

0.013 mg/L

91.3%

7.24

50psi

0.03

0.03±10%

0.1

Chromium (Trivalent)

0.17 mg/L

.01 mg/L

94.1%

7.24

50psi

0.01

0.03±10%

0.1

Copper Reduction

3.1 mg/L

0.03 mg/L

99.0%

7.64

50psi

0.04

3.0±10%

1.3

Cysts

222,077#/ml

10 #/ml

99.99%

5 8 minimum 50,000/mL

Fluoride Reduction

8.0 mg/L

0.5 mg/L

93.9%

7.49

50psi

0.7

8.0±10%

1.5

Lead Reduction

0.15 mg/L

0.002 mg/L

98.6%

7.49

50psi

0.003

0.15±10%

0.010

Radium 226/228

25pCi/L

5pCi/L

80.0%

7.24

50psi

5pCi/L

25pCiL±10%

5pCiL

Selenium

0.10

0.008

92.0%

50psi

0.011

0.10±10%

0.05

TDS

96.8%

7.84

750±40mg/L

187

Turbidity

10.2 mg/L

0.26 mg/L

97.5%

0.83

11±1 NTU

0.5 NTU

Note: Depending on water chemistry, water temperature, and water pressure Watts Premier’s R.O. Systems production and performance will vary.

Efficiency rating means the percentage of the total water required to operate the system that is treated and available to the user.

REFER TO OWNER’S INSTALLATION/SERVICE MANUAL FOR FURTHER MAINTENANCE REQUIREMENTS AND WARRANTY INFORMATION.

Phone: (623) 931-1977

Fax: (623) 931-0191

Email: wpmail@wattsind.com

GENERAL USE CONDITIONS:
1. System to be used with municipal or well water sources treated and tested on regular basis to insure bacteriological safe quality. DO NOT use with
water that is microbiologically unsafe or unknown quality without adequate disinfection before and after the system. Systems certified for cyst
reduction may be used on disinfected water that may contain filterable cysts.
2. Operating Temperature:

Maximum: 100°F (40.5°C)

Minimum: 40° (4.4°)

3. Operating Water Pressure:

Maximum: 100 psi (7.0kg/cm2)

Minimum: 40 psi (2.8kg/cm2)

4. pH

3 to 11

5. No iron present in incoming feed water supply.
6. Hardness of more than 7 grains per gallon (120 ppm) may reduce TFM membrane life expectancy.
7. Recommend TDS (Total Dissolved Solids) not to exceed 1800 ppm.

Model No.

Avg.

Avg. TDS DPR

I n f l u e n t

Effluent

IN /EFF

RECOVERY

GALLONS

EFFICIENCY

TDS

REDUCTION

765 mg/l