Do’s And Don’ts
SOME DO’S
1. Do comply with all local plumbing and electrical codes.
2. Do install pressure-reducing valve if inlet pressure exceeds 90 psi.
3. Do install gravity drain on salt storage cabinet. See fi gure 7.
4. Do secure drain line on appliance and at drain outlet. See fi gure 3.
5. Do allow a minimum of 8 to 10 feet of pipe from the outlet of the water conditioner
to the inlet of the water heater. See fi gure 1.
SOME DON’TS
1. Do not install if checklist items are not satisfactory.
2. Do not install if incoming or outlet piping water temperature exceeds
120 degrees Fahrenheit. Please see specifi cations on page 30.
3. Do not allow soldering torch heat to be transferred to valve components or plastic parts.
4. Do not overtighten plastic fi ttings.
5. Do not place appliance right up against a wall which would deny access to plumbing. See
fi gure 1.
6. Do not install the appliance backwards. Follow arrows on inlet/outlet. See fi gure 2.
7. Do not plug the transformer into an outlet that is activated by an on/off switch. See fi gure 8.
8. Do not connect the drain and the overfl ow (gravity drain) together.See fi gure 1.
7
Summary of Contents for Sof-Tek
