AERCO ProtoNode FPC-N34 & FPC-N35 User Manual
CHAPTER 6 – How To Start The Installation Over: Clearing Profiles
OMM-0107_0B
AERCO International, Inc.
•
100 Oritani Dr.
•
Blauvelt, NY 10913
Page
33
of
108
GF-150
Ph.: 800-526-0288
03/07/2017
CHAPTER 6.
How to Start the Installation Over:
Clearing Profiles
•
After setting your PC to be on the same subnet as the ProtoNode (Section 4.1 ), open
a web browser on your PC and enter the IP Address of the ProtoNode; the default
address is
192.168.1.24
.
•
If the IP Address of the ProtoNode has been changed by previous configuration, you
will need to get the assigned IP Address from the network administrator.
•
The Web Configurator will be displayed as your landing page.
•
At the bottom-left of the page, click the
Clear Profiles and Restart
button.
•
Click the
System Restart
button.
•
Once restart is complete, all the past profiles that were discovered and or added via
the Web configurator will be deleted. The unit is now ready to be reinstalled.
•
Complete the instructions in one of the following sections:
o
Section
2.4.2
to Auto-Discover your equipment again.
OR
o
Section
2.4.3
to manually select your equipment again.
