background image

USA:

  T: (800) 752-5582 • F: (623) 866-5666 • PremierH2O.com

Canada:

  T: (905) 332-4090 • F: (905) 332-7068

IOM-WQ-E-Treat   2052 

EDP# 68110143 

© 2020 Watts

Conditions

1.   E-Treat systems are warranted for domestic use in residential single family dwelling applications excluding irrigation water treatment. The 

use of these systems in light commercial, commercial, or industrial applications will void their limited warranty.

2.   The E-Treat system must be installed in applications with municipally supplied water adhering to EPA guidelines. 
3.  Any component failure must not result from abuse, fire, freezing or other acts of nature, violence, or improper installation.
4.  Equipment must be installed and operated in compliance with the local plumbing codes and on an approved water supply.
5.   Equipment is limited to use at water pressures and temperatures that do not exceed our published specifications.
6.   Water supply must not exceed 2.0 PPM chlorine. For water supply exceeding 2.0 PPM chlorine, pretreatment is required.  

(Please contact your water treatment specialist.)

7.   Information, including model number, serial number, and date of installation, must be provided for any claims pertaining to equipment 

in warranty.

8.   Defective parts are subject to inspection by either the Company or its authorized representative before final commitment 

of warranty adjustment is made.

9.   The Company reserves the right to make changes or substitutions in parts or equipment with material of equal quality or value and of then 

current production.

Limitations

Our obligation under this warranty with respect to the tank or valve is limited to furnishing a replacement for, or at our option, repairing any 

part or parts to our satisfaction that prove defective within the warranty period stated above. Such replacement parts will be delivered to the 

owner F.O.B. nearest factory, at no cost, excluding freight and local labor charges, if any.
Our obligation under this warranty with respect to the OneFlow

®

 media will be limited to furnishing a replacement for the media within two 

years from date of original installation. Such replacement media will be delivered to the owner F.O.B. nearest factory, at no cost, excluding 

freight and local labor charges, if any. Damage to the media due to chlorine, other oxidizers or fouling caused by local water conditions or any 

other operation outside of the limits shown under Specifications, is not covered by this warranty.
THE WARRANTY SET FORTH HEREIN IS GIVEN EXPRESSLY AND IS THE ONLY WARRANTY GIVEN BY THE COMPANY WITH RESPECT 

TO THE PRODUCT. THE COMPANY MAKES NO OTHER WARRANTIES, EXPRESS OR IMPLIED. THE COMPANY HEREBY SPECIFICALLY 

DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF 

MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  
The remedy described under this warranty shall constitute the sole and exclusive remedy for breach of warranty, and the Company shall 

not be responsible for any incidental, special or consequential damages, including without limitation, freight, handling, lost profits or the cost 

of repairing or replacing other property which is damaged if this product does not work properly, other costs resulting from labor charges, 

delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any other circum-

stances over which the Company has no control. This warranty shall be invalidated by any abuse, misuse, misapplication or improper  

installation of the product.  
Some states do not allow limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of  

incidental or consequential damages. Therefore the above limitations may not apply to you. This warranty gives you specific legal rights, and 

you may have other rights that vary from state to state. You should consult applicable state laws to determine your rights. SO FAR AS IS 

CONSISTENT WITH APPLICABLE STATE LAW, ANY IMPLIED WARRANTIES THAT MAY NOT BE DISCLAIMED, INCLUDING THE IMPLIED 

WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE APPLICABLE 

WARRANTY PERIODS STATED ABOVE.

Limited Warranty

•   Watts Regulator Co. (the “Company”) warrants the E-Treat system is warranted to be free of defects in materials and workmanship for  

5 years from the date of original shipment.

Summary of Contents for 68101336













Reviews: