Page 7
How to use the Quick Connect Fittings
To make a connection, the tube is simply pushed into the fitting. The unique locking system holds the tube firmly in place
without deforming it or restricting flow. Use the steps below in reference to any quick connect tube connections.
It is essential that the outside diameter be free of score
marks and that burrs and sharp edges be removed before
inserting into fitting.
Fitting grips before it seals. Ensure tube is pushed into
the tube stop.
Push the tube into the fitting, to the tube stop. The collet
(gripper) has stainless steel teeth which hold the tube
firmly in position while the O-ring provides a permanent
leak proof seal.
Pull on the tube to check that it is secure. It is a good practice
to test the system prior to leaving site and /or before use.
To disconnect, ensure the system is
depressurized before removing the tube. Push in the col-
lect squarely against face of fitting. With the collet held
in this position, the tube can be removed. The fitting can
then be reused.
Turn off the cold water supply to the faucet by turning the angle stop valve completely off.
Open cold water sink faucet to relieve pressure.
Step 5
Step 6
Choosing the configuration that fits your plumbing, attach the adapt-a-valve as illustrated in
the four photos above.
*Do not forget to install the white compression washer for 3/8” configuration.
*Brass adapter B does not need to be tightened with a wrench, only finger tight.
Adapt-a-Valve Installation
3/8” Configuration
(With Brass Fittings)
* Insert White Washer
1/2” Configuration
(Without Brass
Fittings)
*
White
Washer
Do not use Teflon tape with the Adapt-a-Valve.
WARNING:
Caution: Water supply line to the system must be from the cold water supply line only.
Hot water will severely damage your system.
A
B
Hot
Supply
Cold
Supply
Hot
Supply
Cold
Supply
Summary of Contents for GTS350C
Page 19: ...Page 19...
