WATTWHEELS LTD
6
TRIP/ODO/MAX SPEED & TIME
To toggle between the various modes short press the on/off key to switch between them. The selected item is located in the bottom left corner of the display
BATTERY DISPLAY CAPCITY
The LCD readout on the handlebar of your Bighorn Hub Bike features a battery capacity gauge (much like the fuel gauge on an automobile). It is
recommended that users stop operating the bike on electric once the bike comes up with a flash icon in the battery indicator and recharges. Remember you
can still ride without using the electric motor or display!
PAS (Pedal Assist Modes)
Pedal assist modes start from 1 and goes up to 5. PAS level 1 is the first pedal assist level and will give you some slight assistance. Press the up and down
arrows on the control panel to toggle between the levels. As you select the higher levels, the assistance will increase with level 5 basically doing all the work
for you. Using higher levels of PAS will drain the battery faster. The recommended level is PAS 1-3 to ensure good battery life. Note- PAS 0 means no
assistance from the motor and you would have this on if you wanted to ride without assistance but measure km/speed etc.
WALK MODE
To activate the walk mode, hold down the - key for three seconds. This will propel the bike forward at around 6km/r. This can be used if you need to walk the
bike up a hill and need some assistance in doing so.
SPECIAL MENU
Please refer to the display manual in the document to access this. But to get into the menu hold down the + & - keys simultaneously for two seconds
Here you can reset trip meter, limit the speed, change PAS power and Sensitivity. We recommend if changing the power or sensitivity of the bike you should
get this done by your local bike shop
Please contact your local retailer if you need any assistance on this. Alternatively, you can check Wattwheels website for up to date instructional videos.
