PTS70014-J
29 MAR 2018
W
E
SERIES :
114 ,116
1726 North Ballard Road, Suite 1 - Appleton, WI 54911 - 920.991.9082
Technical Support 855.804.5774 - Parts@waupacaelevator.com
Wire Rope Tag
(1) To the wire
rope where it
will not interfere
with elevator
operations.
(Tag may vary
due to supplier.)
GAL INTERLOCK
EMERGENCY KEY
- SWITCH MAIN DISCONNECT TO "OFF"
- SLOWLY OPEN HOISTWAY DOOR WITH
INTERLOCK RELEASED
- GENTLY TURN KEY TO RELEASE
INTERLOCK
- INSERT KEY IN KEYWAY UNTIL HANDLE
CONTACTS INTERLOCK
- REMOVE KEY FROM CONTROL BOX
COVER
L-006427-A
GAL
LOCK
DANGER
L-006435-A
Elevator car can
come up and crush
you to death!
Before entering this area:
Pull Emergency Stop
Use a 4 foot brace on
top of car
DANGER
L-006381-A
Elevator car can
come down and
crush you to death!
Before entering this area:
Pull Emergency Stop
Use a 4 foot brace to
support car
(1) To front
wall in the
overhead of
hoistway.
(1) On top of
elevator car.
(1) To hoistway
wall 3’ above
pit facing door.
(1) On the Jack
(1-3) Center in opening/s on toe guard
(1) To controller face next to
emergency key holding bracket.
(EMI interlock)
NON-LOAD
BEARING
SURFACE
L-007722-A
(2) Place label on the
ceiling exterior of
the elevator car.
Label must be visible
from opening
DANGER
L-006428-A
Elevator car can
come down and
crush you to death!
Before entering this area:
Pull Emergency Stop
Use a 4 foot brace to
support car
(1) To the inside of cab
(manual gate only)
(1) To the inside of cab
(automatic gate only)
(GAL interlock)
or
(2) Placed on the
disconnects
110V & 240V
OPERATING INSTRUCTIONS
FOR WAUPACA ELEVATOR WITH MANUAL GATE
IF ELEVATOR STOPS BETWEEN FLOORS WAIT 7 SECONDS AND TRY TO
RETURN TO FLOOR THAT YOU CAME FROM, IF YOU REMAIN STUCK PRESS
ALARM BUTTON TO GET ASSISTANCE IN THE HOUSE OR USE PHONE TO
GET ASSISTANCE.
DO NOT ATTEMPT TO REPAIR THIS ELEVATOR YOURSELF.
CALL DEALER FOR SERVICE OR AN ELEVATOR SERVING COMPANY
DO NOT REMOVE OR COVER THIS SIGN.
L-006432-B
1. Close hoistway door and close elevator gate.
2. If keylock is provided, insert key in lock and turn to “ON”.
3. Press desired fl oor on the car operating panel.
4. Once stopped at landing open gate.
5. Open door and exit elevator.
6. Close the gate.
7. Securely close hoistway door.
8. Should elevator fail to operate.
-Verify gate and hoistway door are fully closed.
-If keylock equipped, verify key is in the “ON” position
-Verify that the emergency stop button is pushed in.
9. Do not load elevator beyond its rated capacity.
10. Do not open gate while elevator is in motion.
11. Keep all body parts inside the elevator car at all times.
OPERATING INSTRUCTIONS
FOR WAUPACA ELEVATOR WITH AUTOMATIC GATE
IF ELEVATOR STOPS BETWEEN FLOORS WAIT 7 SECONDS AND TRY TO
RETURN TO FLOOR THAT YOU CAME FROM, IF YOU REMAIN STUCK PRESS
ALARM BUTTON TO GET ASSISTANCE IN THE HOUSE OR USE PHONE TO
GET ASSISTANCE.
DO NOT ATTEMPT TO REPAIR THIS ELEVATOR YOURSELF.
CALL DEALER FOR SERVICE OR ELEVATOR SERVICING COMPANY
DO NOT REMOVE OR COVER THIS SIGN.
L-006434-B
1. Close hoistway door and the elevator gate will automatically close.
2. If keylock is provided, insert key in lock and turn to “ON”.
3. Press desired fl oor on the car operating panel.
4. Once stopped at landing the gate will automatically open.
5. Open door and exit elevator.
6. Securely close hoistway door.
7. Should elevator fail to operate:
- Verify gate and hoistway door are fully closed.
- If keylock equipped, verify key is in the “ON” position.
- Verify that the emergency stop button is pushed in.
8. Do not load elevator beyond its rated capacity.
9. Do not open gate while elevator is in motion.
10. Keep all body parts inside the elevator car at all times.
(1-3) Place label right next
to the pit stop switch in
the hoistway pit
(1) Place the label
facing toward the
hoistway shaft on the
plastic container that
catches the oil in the
hoistway.
WARNING & SAFETY
LABEL INSTALLATION
Page 5
