CARDIO WAVE EXCITE Class & Trend: Service & maintenance manual- rev.2.0
Pagina 6.32
Follow the procedure step by step to correctly diagnose the problem. Take particular care with the
checks highlighted by circled numbers, which are described in detail below:
(1)
Carry out the “Standard Setting” procedure as detailed at paragraph
“
The speed sensor detects the heads of these bolts.
(2)
Powered models
:
Place the tester probes across the terminals of the speed sensor. The
measured signal should be that indicated in Figure 3.2-1. In addition,
when pedalling at 80 RPM the frequency of the signal should be 136
Hz.
Self-Powered models
: Check the signal on
CU110
cable. The measured signal should be
that indicated in Figure 3.2-1. In addition, when pedalling at 80
RPM the frequency of the signal should be 136 Hz.
The speed signal can also be observed qualitatively, using a multimeter. The value
should be 0 Vdc when the machine is stopped, and gradually increase as the speed
increases.
(3)
Update the low kit SW uploading both firmware and brake table. At the end carry out the
“Default setting” procedure for the low kit parameters.
If you replace Display board/Brake board, check that its SW version is updated,
otherwise install the last version.
Summary of Contents for CLASS & TREND
