Figure 3 Figure 4
2 Canister Heads 2 Media Inserts 2 Canister Housings
Figure 5 Figure 6
Red is Inlet Supply / Blue is Outlet Supply 1 Inch Shark Bite Fitting
Wrap the threads of the Shark Bite with Teflon Tape (provided) 3-4 wraps. Keep it flat
and tight. Place into the Canister Head (do not over tighten) The Canister Head has a Red
Pressure Release Button on the inlet side. This is used when changing the Purification
Media Inserts, by releasing the pressure from the water line.
Remove the head from the housing to ease the assembly of the unit. This is done by
unscrewing it from the housing (see figure 16 A). Use the wrench if needed.
- 2 -
