3. Clip on the lower section 4. Withdraw the split pin.
- 5 -
5. Plug the low voltage cable into the unit
and connect the transformer to the main's
supply. The red light should glow brightly.
Figure 12 A Figure 12 B Figure 12 C
Turn assembly over to attach the Mounting Cover. At this time record the serial number
located under the cover beside the Gauges. Position the cover to line up the bolt patterns
and the pressure release buttons. Pressure Gauges are pre-installed. 8 Lag Bolts are
provided (DO NOT OVER TIGHTEN)
