ISSUE 1 01/09/2017
www.wave-led.com technical@wave-led.com
P2/3
INSTALLATION
ADDITIONAL INSTRUCTIONS FOR USE WITH REMOTE CONTROL (if applicable)
Deck 35
1165, 1166, 1167
For remote control options
Slide the battery cover off the RF controller and fit the battery observing the correct
polarity markings
Press the On / Off button on the RF controller. The red LED should light at the top, and
the signal LED should light on the power supply.
Push the RGB button to switch between the different colours; there are seven individual
colours and two variable modes.
The fixed colour sequence is yellow, white, red, green, blue, purple and light blue.
The two variable modes switch between all seven colours and the other fades between
them.
To synchronise the colours of ore than unit, press and hold the power button for 5
seconds.
Ensure that individual units with RGB capability are positioned no more than 10ft (3m)
apart for the remote control to work on all units effectively.
Step 7
Turn on the circuit breaker and light switch.
When first turned on wait approximately one minute for the circuitry to self calibrate.
TESTING
12V 23A
RGB
Step 4
From underneath the decking, feed the head unit and cable up through each installation hole (A).
Fit the protective cap onto the head unit - to prevent the unit from dropping back through the holes and to keep
debris out (B).
Once the decking has been fully assembled and the lights are ready to be installed, remove the protective cap and
push the LED unit onto the head unit observing the correct polarity - align the flat part of the connector to ensure
correct connection (C)
Step 5
Fit the assembled head units into the holes by pushing into the hole. The springs on the side of the head will secure the head units
in place (D).
Connect all looms together and connect directly to the driver output cable, or the extension cable.
Ensure any unused heads and cable ends are fitted with the end plug and protective cap to prevent the ingress of moisture (E).
Step 6
Connect plug to power supply.
A
B
C
D
E
Step 3
Drill location holes for heads.
Use supplied 15/16” (24mm) drill paddle to drill holes.
Ensure drill is level and 90˚ to surface being drilled.
