SPEEDLAN TM
17
General Setup Menu
The third menu from the left is the Setup Menu. In this menu are the screens you will use to configure your
brouters. Below are descriptions of the menu items and the settings found on their respective screens.
Enable IP Routing
- The transparent routing function will be enabled when this is item is checked. IP Routing
will work properly only if the routes are set up in the IP Route Menu.
If the routes are not set up properly
before you save the configuration, the bridge will become inoperable.
Default is off.
Enable Bridging
- The transparent bridging function will be enabled when this is item is checked. If you want
the brouter to perform the bridging function,you must enable this. When bridging is enabled, the Bridge Setup
Screen will be accessible. Bridging should be enabled for nearly all applications of the brouter. Default is on.
(This function should never be disabled.)
General Setup
Summary of Contents for SPEEDLAN TM 6000
