3.INSTALLATION
EN
11
3.INSTALLATION
3.4. Pool cover and security
After each use, the control panel must be locked and the pool must
be coated with its top cover and it must be attached to the base
protector with the safety buckles.
Each safety buckles has a lock system ; closed buckle, the latch in
up position locks the buckle, the latch in down position unlocks the
buckle.
The top cover keeps the heat from the water and secures the pool.
1. Ch
oose a flat a
nd level
location.
2. Extend the liner to the chosen
area.
3. Add the foam wall segment
with the three holes in it for
connection to the base liner.
4. Adjust the 8 segments until
they form a perfect round shape.
Then, ensure that the holes for
the outer liner connection and
the holes in the foam wall are
still aligned.
5. Install the connection hose on
the liner.
6. Insert the inner liner of your spa.
7. Install the connecting hose
(assemble the short hose and
T-join as shown in the image).
8. Install two-way connector to
another outlet, as shown in the
image.
9. Connect the longest
connecting hose to the T-joint
as shown in the image.
10. Insert the hose into the
groove on the foam, as shown
in image.
11. Connect the other end of the hose of the two-way connector, as
shown in the image.
12. After all hoses are installed, lift the outer cover gently, as shown
in the image.
13. When installed at corner,
push PE foam inward so that
the coat can be installed in
place.
3.3 Assembling
14. Locate the place where
the two zippers are aligned,
connect th
em fi
rst
15. Smooth the liner all around
the SPA to ensur
e a good fi
t.
16. When installed at corner, push
PE foam inward so that the coat can
be installed in place.
17. Locate the place where
the two zippers are aligned,
connect th
em fi
rst.
18. Make sure that the zippers
of the liner and outer liners are
aligned before zipping them up.
19. Connect the unit pump to the
pool using the 3 connectiors to
screw. Ensure the icons on the
pump and the pool match up.
20. Insert the cartridge into its
fi
lter holder and then screw on
the suc
tion fi
tting inside the
basin.
21. Check that the drain plug is
closed properly.
22. Fill the spa pool until the indicat -
ed fill l
evel is reached.
Your spa is ready to be used.
12
C
M
Y
CM
MY
CY
CMY
K
Wave_Installation and user manual_SWIFT US_OUTLINED AND EMBEDDED.pdf 6 10/09/2021 12:05:01