RT9 Powershelf
Rectifier Technologies
158-1806-01.doc
37
2-Mar-06
6.1 To Remove a Rectifier Module or a MiniCSU-3 Controller
Lift the securing latch in the centre divider adjacent to the module and pull the module out
of the Powershelf.
When removing modules, especially if the ambient temperature is high and the unit has
been operating at maximum load, avoid skin contact with the metal casing as it may be too
hot to touch. Pull the unit halfway out of the magazine and let cool for 2-3 minutes before
handling.
6.2 To Insert a Rectifier Module or a MiniCSU-3 Controller
Insert the module into the slot and ensure alignment with the fold-out rails in the magazine.
Push the module all the way in so the rear connector fully mates and the securing latch
spring clicks back down into place.
Figure 6.1
