12
DISPLAY BACKLIGHT
Press the
key to turn the backlight on. The backlight will automatically turn off after
SET time.
Press the
EXIT
button to exit the
backlight on
mode.
HOLD
The hold function freezes the reading in the display. Press the
HOLD
key momentarily to
activate or to exit the
HOLD
function.
PEAK HOLD
The Peak Hold function captures the peak AC or DC voltage or current. The meter can capture
negative or positive peaks as fast as 1 millisecond in duration. Momentarily press the
PEAK
button, “
PEAK
” and “
MAX
” will display in
left auxiliary display
.
MIN
” will display in
right
auxiliary display
. The meter will update the dispay each time a lower negative peak occurs
.
Press the
EXIT
button to exit the
PEAK HOLD
mode.
Auto Power Off feature will be disabled
automatically in this mode.
Data record
（
STORE/RECALL
）
1. STORE function
In the current testing mode, press STORE button one time, enter into STORE function.
On the left upper corner of LCD shows NO XXXX
.
，
which states current storage serial number. Then, press button PEAKHOLD to change into the
initial serial number 0000. (Press again it will change back).
On the right upper corner of LCD shows XXXX
，
which states how many current storage
values are used.
Press STORE button again, enter into recording interval time set up function.
On the left upper shows 0000 S
，
which states recording interval time; using button + & -
to select
，
the range is 0~255 seconds
。
When the recording interval time is 0000 S
，
then press STORE button again to change into
manual recording. Press the STORE button again to record once.
When the recording interval time is 1~255 S
，
then press STORE button again to start recording
automatically from 0000.
Recording times is showed on the left upper corner, data is showed on the right upper corner
(Due to digital limitation, there is only four preceding numbers displayed)
To finish above STORE function, press EXIT button shortly.
If you expect to clear all memory data:
While power on, hold EXIT button, and switch from OFF to random and then release EXIT butt
on, the LCD will flash thrice and buzzer thrice too, which means all memory data is cleared.
Summary of Contents for 98
Page 2: ...2...
