WMO2 G900 / G1800 / G1900
WCOM/GSM/WMO2/WMO2ATDOC
Friday 21 May 1999
WAVECOM confidential ©
23
4
Commands set
For
convenience
the <CR> and <CR><LF> sequences are not
indicated in the examples shown in the following description.
4.1
General commands
4.1.1
Manufacturer identifiCGMI
This command gives the manufacturer identification.
It is only a read command.
There is no possibility to set a value or to test the parameters.
Command Syntax:
AT+CGMI
Example:
Application to GSM
AT+CGMI
Get manufacturer
identification
GSM to application
WAVECOM MODEM
OK
Command valid, Wavecom
modem
4.1.2
Request model identifiCGMM
This command is used to get the supported bands (GSM 900, DCS 1800,
PCS 1900).
The answer could be a combination of different bands in the case of
multiband modem.
It is only a read command.
There is no possibility to set a value or to test the parameters.
Command Syntax:
AT+CGMM
Example:
Application to GSM
AT+CGMM
Get hardware version
GSM to application
900P
OK
GSM 900 MHz primary band, or
"900E" (extended band),
"1800" (DCS), "1900" (PCS) or
"MULTIBAND"
4.1.3
Request revision identification
+CGMR
This command is used to read the software version.
It is only a read command.
There is no possibility to set a value or to test the parameters.
Command Syntax:
AT+CGMR
Example:
Application to GSM
AT+CGMR
get software version
GSM to application
300_D250 641680 012099 18:10
OK
Software release 3.00 generated on the
20
st
of January 1999
