WMO2 G900 / G1800 / G1900
WCOM/GSM/WMO2/WMO2ATDOC
Friday 21 May 1999
WAVECOM confidential ©
1
1
Introduction
This document is intended for every person being brought to work with the
modem WISMO WMO2 G900, G1800 or G1900.
1.1
Document scope
This document presents the technical characteristics of the connections,
interfaces and power supply of the modem WISMO WMO2 in the G900,
G1800 and G1900 terminal version.
This document describes the AT commands allowing the user to issue
communications in the voice, data or fax mode with the modem WISMO
WMO2 G900, G1800 and G1900 and for SMS's reception and expedition.
1.2
Related documents
This interface document is based on the following recommendations and
reference documents:
[1]
ETS 300 019
Environmental conditions and environmental tests
for telecommunications equipment.
[2]
SAE J1113
Transients Voltage Suppression in Automotive
Vehicle.
[3]
WAVE
Internal Qualification Plan version 1.1.
[4]
ETSI GSM 07.05
European digital cellular telecommunication
system (phase 2); Use of DTE-DCE interface for
Short message service and cell broadcast service
[5]
ETSI GSM 07.07
European digital cellular telecommunication
system (phase 2); AT command set for GSM
Mobile Equipment
[6]
ITU-T V.25 ter.
Serial asynchronous automatic dialling and control
[7]
ETSI GSM 03.40
European digital cellular telecommunication
system (phase 2); Technical realisation of the
Short Message Service (SMS) Point-to-Point (PP)
[8]
ETSI GSM 03.38
European digital cellular telecommunication
system (phase 2); Alphabets and language-
specific information
[9]
WMO2sp14
Technical characteristics of the WMO2 modem
line.
[10] SII015 v7.9
AT-Commands interface layer specification for the
phase 2 software of the WMO2 modem line.