We recommend replacing the batteries every 2 or 3 years to ensure that the
device will work properly.
Important:
alkaline batteries may be used in the event of a problem with
the rechargeable batteries, but they can only be used temporarily until new
rechargeable batteries are available. If you use alkaline batteries, make sure that
you do not put the
WaveMon RF
in charge mode, to avoid possible damage to the
batteries and to the device.
10.2 Charging
To charge the
WaveMon RF
battery, connect the
WaveMon RF
cable to a USB
charger or a computer. A full charge takes approximately 4 to 5 hours. The
charge takes place in two stages:
• Charge: the
WaveMon RF
shows the level indicators in blue while the batteries
are charging.
• End of charge: the
WaveMon RF
shows the level indicator in green.
Note:
we recommend making a full charge at least once a month to extend the useful
life of the batteries.
Note 2:
when connected to a computer, the
WaveMon RF
cannot be running the
program and charging at the same time. The procedure is as follows: when it is
connected to a computer, the
WaveMon RF
waits for 3 minutes before going to
charge mode, in case the user wishes to connect the
WaveMon RF
to the computer
program and download measurements. After 3 minutes without detecting the PC
program, the
WaveMon RF
switches to battery charge mode. If the device is in charge
mode and you wish to connect the
WaveMon RF
to the computer program, you will
need to disconnect it and then reconnect the USB to have the program recognise it.
User’s Manual
Personal equipment WaveMon
P.
18
Summary of Contents for WaveMon RF
Page 2: ......
Page 32: ......
Page 33: ...www wavecontrol com...
Page 34: ...Safety Quality Service 34 93 320 80 55 www wavecontrol com info wavecontrol com...
