WaveMark Document 97-0009 Rev B
Yellow Barcode light (solid yellow when Barcode function is operational; in this state, the
Barcode button can be used to read a Barcode. When the yellow light is not lit, this button
performs no function).
Use only the charger that is supplied with the WaveMark SmartWand (WaveMark part number 90-
0094-R charger and 90-0095-R international plug kit). Select the plug that is appropriate for the
electrical receptacles in your area.
The WaveMark SmartWand should be charged with the power slide switch in the off (left) position.
When charging, the power light will be flashing green. When fully charged, the power light will be
solid green. Do not use the WaveMark SmartWand to read RFID tags or Barcodes while it is
charging. A full charge will take approximately 6 hours, but shorter charging cycles will provide a
partial charge. It is OK to leave the charger connected to the WaveMark SmartWand for extended
periods of time, as long as the power switch is “off”. The charger is a multi-stage “smart” charger
designed to sense the condition of the battery and provide protection against over- and under-
charging.
Barcode Light
Install Plug
Select Plug Style
Remove Filler
