English
•
To switch off the
BASE
, push on the VOLUME knob for more than 4 seconds.The STANDBY
indication is red.
•
Adjust the
BASS
and
TREBLE
level by the tone controls below the VOLUME knob.
•
If you emphasize the bass control too much, the maximum total volume will be limited since the
woofer may run at overstroke earlier. Please care not to overload the speaker drivers too much
(audible distortions) since this can reduce the life-span of the speakers!
•
Auto shut OFF:
if the input signal is very low or off for more than 2 hours, BASE automatically
switches to
STANDBY
mode.
Playback of Audio Sources with RCA- or 3.5mm Phono sockets
For audio sources with RCA- or phono outputs, connect to
LINE
RCA (Cinch) sockets on the
BASE
backside.
Switch ON your
BASE
by short push on the VOLUME control knob (right side topmost knob).
Control the volume as required.
Bluetooth® Audio Playback
Activate the
Bluetooth® (BT /
)
function of your audio source (e.g. your smartphone).
Switch on
BASE
by short push on the VOLUME knob (right side topmost knob). Select
BT
by another
short push, the indication changes to blue light.
1.
BASE
confirms the activation of its Bluetooth® function through the blue control LED.
In case an earlier connected BT source is available,
BASE
will instantly connect to that BT source
again. When connected, the BT control confirms by a short signal tone. Now you can start BT
playback through
BASE
.
2. In case no prior connected source is available, after few seconds,
BASE
will search for new BT
sources.
Now, start the Bluetooth® search function of your BT souce (e.g. smartphone). After a moment, you
can find “
wm BASE
“ in the BT devices list of your BT source. Select “
wm BASE
“ for pairing. Your
BT source will now pair with
BASE
. Once the pairing procedure is finished the
BASE
confirms by a
short signal tone.
When the BT connection is interrupted through foreign signals interference or by too long distance, the
playback interruption is confirmed by a short signal tone. Once the BT source can be received again,
playback continues and it confirms by a short signal tone again.
To switch off the Bluetooth® function short push on the VOLUME knob to select the LINE input. This
will completely deactivate the built-in BT function.
Headphones playback
Below the tone controls you can find a 3.5mm headphones socket. Once the headphones plug is
inserted, the BASE speakers will be deactivated. The BASE volume control is also working for the
headphones output. The tone controls are dedicated to the speaker playback, there is no effect for the
headphones playback.
By removing the headphones plug, the
BASE
speakers will be activated again.
3
