6. Battery and Charger
(Only for WAVEN GILBOT) Lithium-ion battery Yo
u should use a dedicated rechargeable battery.
This WAVEN GILBOT battery has the following specifications.
(BMS board in the WAVEN GILBOT battery maintains the battery safely.)
24V 30A (lithium-ion)
If the battery is properly managed, it is usually possible to drive 30km.
If the scooter is not in use for a long time, recharge it periodically.
※
Do not use a car battery. Car batteries cannot be used for a long time and are not buffered. It is
also not safe to use as the main power source for scooters.
- Move the scooter as close to the standard power outlet as possible.
- Turn off the scooter and remove the key from the main key switch.
- Open the charging port on the scooter
- Insert the XLR connector into the charging port.
- Plug the power cord of the charger into a power consent.
- Once the charging is completed, disconnect the charger power cord from the power outlet.
(For safety reasons, the scooter does not operate during charging.)
* It takes 4 to 7 hours to charge the battery, depending on its specifications and conditions.
When the battery is fully charged, the charger LED indicates a green light. Recharging the b
attery for longer than necessary is not good for battery maintenance. It is usually recomm
ended to charge for 4 to 7 hours after use.
BATTERY & CHARGER
WAVEN GILBOT Mobility Scooters User Guide
20
Summary of Contents for GILBOT
Page 1: ......
