The Hardware
(1) – WaveR8 Card
(2) – Micro USB port
(3) – Status LED (green)
(4) – Transfer LED (blue)
(5) – Contacts (Back)
The USB Port
The USB port on your WaveR8 is used to transfer data from your
computer to WaveR8. It is a USB-B-Micro connector.
To guarantee the longevity of your WaveReX we have chosen a
USB connector that is fixed to the board with four solder pads.
Additionally, the connector is fixed with 2-component glue.
Breaking the socket is therefore excluded as normal wear and
tear.
WaveR8 is powered by your device as well as by USB, depending
on which voltage is higher.
Attention!
In new condition, the connector may still be slightly tight.
Never insert your USB cable by force, as you can destroy
the connector!
The Card
The card was manufactured in a sandwich process from con-
ventional PCB material. The layers are both soldered and glued.
The lid is made of stainless steel and protects the internal elec-
tronic components. It is also firmly glued. Trying to open the card
or the lid will destroy your WaveR8. During normal operations
there is no reason to open the card.
If you should have problems that your card is not recognized,
please refer to the
Troubleshooting
chapter.
11
5
4
2
3
1
Summary of Contents for WaveR8
Page 1: ......