Here you can see the size of the card in bytes. Please note that
even with an empty card 12288 bytes of the card are always oc-
cupied by the card format.
Click on
Send Card
in the lower right corner to start the transfer.
The left corner of the WaveR8 will flash blue to indicate that the
transfer is in progress. You can see the progress of the transfer
on the progress bar of the software. After a few seconds the
transfer should be completed, and the blue LED will turn o
ff
.
The status display informs you if the transfer was successful.
If the transfer was not successful, the status
Transfer Failed
is
displayed. In this case, check if your WaveR8 is connected to the
computer and is displayed as described above under Device.
And now into the R-8...
If the transfer was successful, close the software editor. Now
unplug the micro USB connector from your WaveR8 and make
sure your R-8 is o
ff
.
Caution!
Never plug your WaveR8 into your R-8 while it is live, especially
when the R-8 is powered on. This can cause serious damage to
your R-8.
Insert your WaveR8 into the MEMORY CARD 1 (ROM) bay of the R-
8 with the label up and the golden contacts (bottom) in front.
Here you will feel a slight resistance.
Slide your WaveReX straight into the shaft to the stop. The card
is correctly inserted when the
Sound Library
lettering is at the
level of the chassis.
Turn on your R-8 now.
If the card sits correctly in the bay, the upper right corner of Wa-
veR8 lights up green, signaling that WaveR8 is powered by the
R-8.
Pay attention to whether you see a small 1 in the display under
Card. This signals that WaveR8 has been recognized as a card
AND the card content is valid.
According to the function of the R-8, the card must first be
loaded into the internal memory of the R-8. To do this, select the
Card Menu by pressing the
Card
button. Now press the key 4 on
the number field of the R-8 for
LOAD ROM
and then the key 1 for
SOUND
if you only want to load the card sounds or 2 for
31
Summary of Contents for WaveR8
Page 1: ......