® Waves System
V 2.0 - 2007
I.D. AL - SP203 - Professional MP3 audio player - Manual
- 8 -
5. HARD DISK INSTALLATION OR CHANGE
4. Hard disk installation (Removable HDD version only)
If you have purchased your player without hard disk or if you want to upgrade the installed one, you will
need a Philips screwdriver for this operation.
Before proceeding, the PLAYER MUST BE SWITCHED OFF AND THE POWER SUPPLY UNPLUGGED. If
you don’t feel confident in carrying out this operation, contact a qualified specialist or an authorized
service station.
1 - Remove the tray
2 - Slide out the tray cover
3 - If a HDD is already installed, remove the 4 screws. Gently lift off the disk then disconnect the IDE
interface cable (ribbon cable) and power supply. Avoid brute force.
4 - Install a new formatted hard drive on which the MP3 files have been stored. Warning: you must
configure your hard disk as “ MASTER ”. Read the hard disk manufacturer’s documentation to set
configuration jumper(s) in “MASTER ” position.
5 - Connect the 40 pin connector. This connector is keyed.
7 - Place the hard disk in front of the holes and secure it with the 4 screws.
8 - Replace the tray cover and insert the tray back in the player.
Note, the switch must be
closed when the player is
in use but you must open it
to remove the tray.
NEVER OPEN NOR CLOSE
THE SWITCH WHEN THE
PLAYER IS POWERED UP
