- 58 -
23.
This appliance is not designed for commercial use.
24.
Do not use the appliance for other than intended use.
25.
Do not operate the appliance without water to avoid damaging the heating elements.
26.
Do not wind the power cord around the appliance during storage. This could cause damage to the cord
and lead to danger of short circuit, electric shock or fire.
27.
Should you accidentally allow the kettle to operate without water; the boil-dry protection will
automatically switch it off. If this should occur, allow the kettle to cool before filling with cold water and
re-boiling.
28.
Always take care to pour boiling water slowly and carefully without tipping the kettle too fast.
29.
Do not touch the hot surface. Use the handle or the button.
30.
Extreme caution must be used when moving an appliance containing hot water.
31.
The kettle is for household use only, not for outdoor.
32.
Our warranty does not cover water kettles that malfunction resulting from failure to descale.
33.
Do not boil anything but water in this water kettle.
HOUSEHOLD USE ONLY
PARTS DESCRIPTION
1.
Lid
2.
Handle
3.
Water gauge
4.
On/Off switch and indicator light
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you clean your kettle before use by boiling
a full kettle of water twice and then discarding the water.
OPERATION OF YOUR KETTLE
1.
Open the lid; pour out left over water from previous boiling cycle and fill with the desired amount of fresh
water to the water kettle. Always fill the kettle between the minimum (0.5L) and maximum (1.0L) marks.
Too little water will result in the kettle switching off before the water has boiled.
NOTE:
Do not fill the water over the maximum level, as water may spill out of the spout when boiling.
Ensure that the lid is firmly in place before connecting the power cord to the outlet.
2.
Connect the plug into a power outlet. Press the On/Off switch downwards and the kettle starts to boil the
water. The indicator will light up. The kettle will switch off automatically once the water has boiled. You
can shut off the power by pressing the On/Off switch upwards at any moment during boiling water.
NOTE:
Ensure that the switch is clear off obstructions and the lid is firmly closed. The kettle will not turn
off if the switch is constrained or
the lid hasn’t been c
losed.
3.
Once the water boils, wait 10 seconds before pouring out water to prevent hot steam from exiting through
the lid of the kettle. Take the plug out of the outlet. Lift the kettle, then pour the water.
NOTE:
Operate carefully when pouring the water from your kettle as boiling water will scald.
4.
The kettle will not re-boil until the switch is pressed again. Allow the kettle to cool down for 30~40
seconds before reopening to boil water. Never re-boil water older than 2 hours.
NOTE:
Ensure power supply is turned off when kettle is not in use.
5.
Should you accidentally allow the kettle to operate without water, the boil-dry protection will
Summary of Contents for WK-126615.2
Page 1: ......
Page 49: ...48 Bulgary BG 1 8 2 8 3 8 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21...
Page 50: ...49 22 23 24 25 26 27 28 29 30 31 32 33 1 2 3 4 1 0 5 1 0 2 3 10...
Page 51: ...50 4 30 40 2 5 1 2 1 25 15 5 6 220 240V 50 60Hz 1000 1200W 2...
