Copyright © 2020 Wavesplitter AV Technology
|
Wavesplitter .com
TEL
：
1-510-0651-7800
：
sales@wavesplitter.com
OPERATION MANUAL
●
Available Units (right): All known transmitters and receivers that are not currently controlled by this IP Master Controller will
be listed here. To allow a device to be visible and controllable, click on the device’s button in the right panel and it will
move to the left panel. Clicking on either respective “All” button will move all transmitters or receivers to the left panel
making them visible to, and controllable by, this unit after “Save” has been clicked.
1)
Group
：
This section provides a way to collect multiple receiving endpoints into single groups to be used as simple,
single click, targets for routing A/V, USB or IR/RS-232 sources. Once created, each group will appear within the
appropriate section of the Monitor & Control tab along with standard receivers.
●
Device Group List
：
The upper-left section contains a list of all currently defined groups and provides a way to
create new groups,
edit them, or delete them. To add a new group, click on the “Add”
icon ( ) and then select
the preferred options and endpoints. To edit an existing group, click on the
“Edit”
icon ( ) and then make
whatever changes are required. Once a new or edited group has been
configured, click on the “Save Group”
button at the bottom of the page
to store the group. To delete an existing group, click on the “Delete”
icon ( )
next to the appropriate group name.
Note: Leaving this screen before selecting “Save Group” will undo any
changes made.
●
Order
：
Use the dropdown to select the position within the group list for the currently selected group.
Note: The order in the list also impacts the order groups are displayed within the Monitor & Control tab.
●
Group Name
：
Type the preferred name for the currently selected group.
●
Group Type
：
Select the media type contained within this group. Options are: Video/Audio, USB, and IR/RS-232.
This selection will determine the type of receiver endpoints available within the Device List.
●
Group List
：
This section contains all of the receiving endpoints that are assigned to the currently selected group.
Clicking on an endpoint will remove
it from the group and place it back in the “Device” section.
To remove all
devices from the current group, click on the “Remove
All”
button.
