Copyright © 2020 Wavesplitter AV Technology
|
Wavesplitter .com
TEL
：
1-510-0651-7800
：
sales@wavesplitter.com
OPERATION MANUAL
Note
：
If no display is detected the button will turn red.
●
Network Settings
：
Clicking this button will display a pop-up window containing detailed information about the
unit’s current network
settings, including IP mode, and allow for those settings to be changed. To activate any
changes made, please click on the “Save”
button to close the window.
●
RS-232 Settings
：
Clicking this button will display a pop-up window containing detailed information about the
unit’s current RS
-232 settings, including baud rate, and allow for those settings to be changed. To activate any
changes made, please click on the
“Save”
button to close the window.
●
Device Settings
：
Clicking this button will display a pop-up window providing control over a number of important
device settings and allow for those settings to be changed. To activate any changes made, please click on the
“Save”
button to close the window.
1.
Version
：
Display the
unit’s
current firmware version.
2.
System Command
：
Use the dropdown to select a system
command to send to the unit. Typically available commands are:
▼
N/A
▼
Factory Reset.
▼
Reboot
▼
Firmware Update
3.
Name
：
Change the
unit’s
name (19 character maximum).
4.
HDMI Audio Source
：
Select the audio source type to embed
with the HDMI video output of this unit. Available options are:
▼
HDMI Audio (Follow Video In Bypass Mode)
：
Output the HDMI audio routed to this unit unless the receiver has
been
set to “Bypass
Mode” in the scaling tab. When “Bypass Mode” is active, only the
native HDMI audio
from the routed video source can be output.
▼
Analog Audio
：
Output the analog audio routed to this unit.
▼
HDMI Audio (Stereo Downmix)
：
Output the HDMI audio routed to this unit after downmixing it to LPCM 2.0.
Note
：
This mode only supports HDMI sources with LPCM audio.
▼
HDMI Audio (All Channel)
：
Output the HDMI audio routed to this unit.
Note
：
This mode only supports HDMI sources with LPCM audio.
5.
Analog Audio Source
：
Select the audio source type to output from the analog audio output of this unit. Available
options are:
▼
HDMI Audio (Stereo Downmix)
：
Output the HDMI audio routed to this unit after downmixing it to stereo.
Note: This mode only supports HDMI sources with LPCM audio.
▼
Analog Audio
：
Output the analog audio routed to this unit.
6.
HDMI Audio Follow Video
：
Enable or disable HDMI audio follow video rules for this receiver. When enabled, any HDMI
video source switched to this receiver will automatically also route the that
transmitter’s
HDMI audio to this receiver.
Note
：
This setting overrides any manual routing selections made from the HDMI Audio routing tab.
7.
Analog Audio Follow Mode
：
Use the dropdown to select the automatic audio follow behavior for this
receiver’s
