Wavetronix Click 112, Manual

12 of 15

WX-501-0518 • 01.22

See the earlier Navigating through the Menu and the Menu Operation Example sections for how to configure this 

parameter.

Because this parameter can also be set by the DIP switches, you may need to ensure that the DIP switches are 

set to 

Software

 configuration mode; if they are set to 

Hardware

, the front panel menu will be able to display but 

not change these settings.

Reset to Default Settings

The final option that comes up in the menu is Reset to Default Settings. To select this function, release the mode 

switch when the red LED starts flashing.

Note. 

Resetting to default settings can also be done using Click Supervisor.

This function will restore all configuration settings to factory defaults, even those parameters not configured using 

the front panel menu: baud rate, channel input map, description field, location field, and device ID.

Level 1 LEDs

Reset to default settings

Level 2 LEDs

Cancel and exit menu

LED off

Reset to default settings

LED on

See the earlier Navigating through the Menu and the Menu Operation Example sections for how to view this 

parameter.

After the Click 112/114 has reset to factory defaults, it will check the DIP switches; if any of them are set to 

Hardware

 mode, it will apply those settings to the parameter in question. If resetting to factory defaults doesn’t 

change certain settings the way you expected it to, check the DIP switches to see if they are causing settings to 

be changed to something other than the default.

Click Supervisor

Click Supervisor is the only way to configure non-data path type parameters such as the description, location, and 

device ID. See the knowledge base article 

0514 Installing and Using Click Supervisor

 for instructions on how to 

download and install Click Supervisor and how to connect to your device using the software.

Note. 

Some of the parameters mentioned below can only be configured in Click Supervisor. Others can be 

configured by the front panel menu and/or the DIP switches. In the case of the DIP switches, if that parameter is 

set to 

Hardware

 mode, it will be grayed out in Click Supervisor, meaning you can view but not change the setting. 

If you would like to set it using Click Supervisor, you will have to turn off all those switches on the device.

The Click 112/114 can be configured using the Expert driver (see the figure below).