7 of 15
WX-501-0518 • 01.22
S5: Bus 1 Baud Rate
1
2
3
Value
Off
Off
Off
Software mode
Off
Off
On
9600 bps
Off
On
Off
19200 bps
Off
On
On
38400 bps
On
Off
Off
57600 bps
S5: Bus 2 Baud Rate
4
5
6
Value
Off
Off
Off
Software mode
Off
Off
On
9600 bps
Off
On
Off
19200 bps
Off
On
On
38400 bps
On
Off
Off
57600 bps
If any switch is on (up),
Hardware
mode is selected, meaning the baud rate can only be changed using the DIP
switches (as shown in the tables above), and Click Supervisor and the front panel menu will be able to display the
current setting, but not change it.
If all switches are off (down),
Software
mode is selected and Click Supervisor and the front panel menu will be
able to both display and change the current setting.
Front Panel Menu
The front panel of the device features a push-button and three banks of LEDs for on-device configuration and
monitoring. The first bank of LEDs, labeled Channel, displays the state of the contact closure outputs and is
described in the Physical Features section.
The two lower banks of LEDs, labeled Menu, and the push-button, labeled
Mode Switch
, are used for navigating
through Menu mode. This section will cover how to use the menu to configure the Click 112/114. The lower bank
of LEDs will be referred to as Level 1 and is used in selecting menu options. The upper bank will be referred to as
Level 2 and is used in configuring the menu options. Level 2 LEDs only light up when a menu selection is made
using the Level 1 LEDs.
Menu
PWR PU
TD
RD
Level 1
Mode Switch
Level 2
1
2
3
4
Note.
The LEDs in the lower bank also function as activity/status indicators. These functions, outlined in the
Physical Features section of this document, are only executed when the device is not in Menu mode. In this case,
the upper bank of LEDs (Level 2) remains off.
Navigating through the Menu
The mode switch push-button is used to enter Menu mode. To use the menu:
1. Press and hold the mode switch to enter Menu mode. The Level 1 LEDs will start to light up to indicate that
the device is cycling through all menu options (specifics on these menu options, and which LEDs and LED
combinations represent them, will be covered later in this section).
2. Release the mode switch when you reach the desired menu option. (Pressing and holding again will resume
cycling through menu options.)
3. Quickly press and release the mode switch to select the current menu option. Once it’s selected, the Level 2
LEDs will start to let you configure the options for the selected menu option.
