SmartSensor 105 User Guide – Wavetronix LLC
9/20/07
- -
21
Undoing Manual Changes
Unsaved changes may be undone without repeating the manual configuration process.
Click on the
Undo
button found below the manual tool buttons (see Figure 12). This tool
retrieves the last saved configuration from the SmartSensor, effectively undoing any
unsaved changes that were made.
Restarting Lane Configurations
To completely erase the SmartSensor’s current configuration and restart the Lane
Configuration routine, change from Manual back to Automatic mode by clicking on the
Automatic
button and then clicking on the
Restart
button located near the
Update
and
Undo
buttons below the Manual toolbar (see Figure 12).
This erases all manual changes that have been made, and the SmartSensor Manager will
automatically reconfigure the road for you.
Figure 13 – Confirmation of Restart
After clicking on the
Restart
button, a window will be displayed asking whether you
want to proceed (see Figure 13). Click on
Yes
to continue or on
No
to quit this
procedure.
Exiting the Lane Configuration Page
Once all automatic and manual configurations have been completed, you may perform a
final save and exit the Lane Configuration page by clicking on the
Finished
button
located at the bottom right of the screen.
Summary of Contents for SMARTSENSOR 105
Page 7: ...SmartSensor 105 User Guide Wavetronix LLC 9 20 07 7 Table 1 Mounting Height Guidelines...
Page 12: ...SmartSensor 105 User Guide Wavetronix LLC 9 20 07 12 Figure 6 Long Distance Cable Run...
Page 34: ...SmartSensor 105 User Guide Wavetronix LLC 9 20 07 34 Table 7 Belden 9331 Old Cable Conversions...
