41
Data Output
The Data Output that you want to test.
Base Test Msg
Defines the base value of the test messages to be output during the test. During the test, the system will
add a sequential number value to the Base Test Msg to form the complete test message, with the
sequence value changing at each test interval.
Test Pager ID
Defines the Pager ID value (address) to accompany the test message. The Pager ID value does not
change during the test cycle.
Repeat Test Interval
Defines the test output time interval, in seconds.
Max Test Repeats
Defines the maximum quantity of output test intervals to perform. Once the Max Test Repeats value is
reached, output testing will stop and the Test Active value will be reset in the system. You will need to
refresh this page to see the Test Active state change occur.
Max Msg Age
Defines the maximum age, in seconds, of a given test message. When a given test message age reaches
the defined Max Msg Age value, the message will be cancelled for any Data Outputs that support
message cancellation.
Test Active
Once checked, the system will commence testing the specified output, using the parameters defined on
this page. Once the Max Test Repeats value is reached, output testing will stop and the Test Active value
will be reset in the system. You will need to refresh this page to see the Test Active state change occur.
If you uncheck the Test Active checkbox, the testing cycle will stop.
System Events
EP
The System Events page allows configuration of how RMS system generated events are reported. The
System Events menu item is only available when Event Processing is enabled.
