Wavin Tempower Control Manual
Wavin Tempower Control
Heating and Cooling systems
.
Wavin Tempower Control Manual
Wavin Tempower Control
Heating and Cooling systems
.
39
9
9..4
4 C
Co
on
nn
ne
ec
ctt W
WT
TC
C--3
3 w
wiitth
h lla
ap
ptto
op
p
c
co
om
mp
pu
utte
err
To create a proper connection between your laptop and
the WTC-3 base unit, the WTC-3 communication cable
must be used. This cable is available only within Wavin
Group.
9.4.1. Configuration
program
9.4.1.1
Connect the communication cable
The interface needs to connect the USB port of the laptop and
the RS port of WTC-3
Note:
the WTC-3 must be powered, otherwise the connection
cannot be established.
9.4.1.2
Set the address
The program and WTC-3 must be on the same address. Set dip
switch 1 on the communication switch of WTC-3 as shown
below:
9.4.1.3
Start the PC software
Major functions
Set Master and Slave WTC-3
Set Dehumidifier to the requested output
Set Master and Slave thermostat
Set mode of control ( BMS, Master thermostat , all
thermostat)
Set requested thermostat inactive mode in case of
cooling
Set reference temperature for heating per thermostats
Set reference temperature for cooling per thermostats
Set reference temperature for economy mode per
thermostats
Set + / - temperature range per thermostats
Set mixed inlet temperature for heating
Set mixed inlet temperature for cooling
Set time delay for heating/cooling changeover
Save configuration in requested folder in html file
format
Print the set and saved configuration
Load saved configuration
Load factory defaults
Update software for new version
Data reading possibilities
Settings of thermostats
heating/cooling reference temperature
economy temperature
master/slave
temperature range
cooling mode active/inactive
Actual room temperature per thermostats
Actual room relative humidity per thermostats
Actual dew point temperature per thermostats
Locally set temperature on the thermostats
Dew point detection per thermostat (only in case of
dew point sensor is connected)
Open window detection per thermostat (only in case of
sensor is connected)
Actual mixed inlet water temperature
Actual outputs status
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
TELEPHONE
+31 (38) 4294911
4
info@wavin.com
www.wavin.com
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
