Wavin Tempower Control Manual
Wavin Tempower Control
Heating and Cooling systems
.
Wavin Tempower Control Manual
Wavin Tempower Control
Heating and Cooling systems
.
9
Design Manual
TELEPHONE
+31 (38) 4294911
4
info@wavin.com
www.wavin.com
5
5.. W
WT
TC
C--3
3 B
Ba
as
se
e U
Un
niitt
5
5..1
1 G
Ge
en
ne
erra
all d
de
es
sc
crriip
pttiio
on
n
WTC-3 base unit is developed to control up to 7
thermostats and up to 21 actuators connected to the
hydraulic installation. The controller drives the actuators
according to the information received from each thermo-
stat and the system parameters settings. The controller is
usually located close to the hydraulic system manifold.
5
5..2
2 W
WT
TC
C--3
3 M
Ma
ajjo
orr ffe
ea
attu
urre
es
s
Controls up to 7 room thermostats.
Contols one or more dehumidifier with DRT-200.
Monitors dew point via the relative humidity
sensor of the room thermostat
Up to 21 actuators can be connected
Changeover heating and cooling mode
Energy saving mode/economy mode
Three built in programs
Room humidity control via a separate
de-humidifier
Pump control (frequency changer control)
Boiler/chiller control
Operation with optional timer Comfort/Economy
mode
Master and Slave Setting option
Emergency Pump stop in case of overheat.
Connection possible to a Building Management
System (BMS) via BUS
Software to test, update and presetting datas
5.2.1. Placing and connecting power
Mount the WTC-3 within 0,8 meter of the
actuators. If this is not possible, you will need
to extend the actuator wires.
Use a standard electrical box to install
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Click the base unit onto the rail
Always connect the WTC-3 to a separate circuit
breaker.
C
CA
AU
UT
TIIO
ON
N: Before wiring, disconnect the electrical power to the
system to prevent electrical shock and damage to the device.
5.2.2. Connect two or more WTC-3 together :
Master and Slave WTC-3
Turn all DIP switch to upward position that
means :0
This settings will define the master WTC-3
The Slave WTC-3 must have different settings
like 1,2,3...
The last Slave has to be closed with the BUS
switch. Turn it to the corner. See below picture
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
