Installing the Wavion WS-410 Metro Access Point
Installation Guide
11
Preparing for Installation
The Wavion WS-410 must be installed by a trained professional, or systems integrator who is
familiar with RF planning issues and regulatory limits as defined by the governing body of the
country in which the unit will be installed.
The following lists the equipment required for installation and explains how to prepare the
installation site.
Installation Hardware and Tools
Wavion provides the following accessories to install the Wavion WS-410:
•
One pole bracket
•
Two 3-6-inch diameter worm drive hose clamps
•
Seven 8mm stainless steel hex head machine bolts
You must supply the following tools:
•
Allen wrench - 4mm and 5mm
•
1/4-inch flat blade screwdriver
•
Wood brace mounting only: four 5/8-inch diameter, 3-inch long lag bolts
C
AUTION
:
Only UL listed parts and components will be used for installation. Use UL
listed devices having an environmental rating equal to or better than the enclosure
rating to close all unfilled openings.
C
AUTION
:
To maintain Overvoltage (Installation) Category II, install a suitable surge
suppressor device in the branch circuit to limit expected transients to Overvoltage
Category II values. The limits are based on IEC60664 and are also located in Table
2H of UL60950 (for mains 110V, the transient rating is 1500V).
C
AUTION
:
The WS-410 must be installed only with the equipped antennas.
C
AUTION
:
A minimum distance of 40cm from the WS410's antenna should be kept
when the system is operated.
C
AUTION
:
Read and save these instructions. Heed all warnings. Follow all
instructions.
W
ARNING
:
Do not modify the construction of this product. Modifying the operating
frequency or enhancing the transmit output power through the use of external
amplifiers or other equipment is illegal.
W
ARNING
:
This device is for use outdoors or indoors on the condition that operation
of this device causes no harmful interference to authorized radio stations. This device
shall not influence aircraft security and/or interfere with legal communications. If this
device is found to cause interference, the operator of this equipment shall cease
operating this device immediately.
Summary of Contents for WS410
