D Mode CT
DRAFT 6
3
Copyright © 2005 Waxess
48091000), and connect it to the DC IN 9V jack and to a
standard 120V AC.
Wall mount
1
Attach the wall mount adaptor to the base.
2
Find the base AC adaptor (the larger adaptor, Model number
48091000), plug the connector into the DC IN 9V jack, then
plug the telephone line cord to the TEL LINE jack.
3
Wrap the AC adaptor inside the molded wiring channel, then
wrap the cord around the strain relief notch.
4
Raise the antennas to a vertical position.
5
Align the mounting slots on the base with the mounting posts
on the wall plate. Then push in and down until the phone is
firmly seated.
6
Connect the handset cord to the jacks on the handset and
base, then set the corded handset in the cradle.
7
On the base, remove the handset retainer, flip it over, then
replace it.
Base power on
When powered on for the first time, the
base goes through an initialization
sequence.
Note:
Do not use the phone until the
initialization sequence is
complete.
d mode ct draft 6.book Page 3 Wednesday, March 2, 2005 10:33 PM