Red Llama
™
instruction manual
WHE-
206
SPECIFICATIONS
INPUT IMPEDANCE..................................................................100 kΩ
OUTPUT IMPEDANCE.............................................................< 10 kΩ
NOISE FLOOR........................................................................-75 dBV
BYPASS..............................................................True Hardwire Relay
CURRENT DRAW........................................................................5 mA
POWER SUPPLY................................................................ 9 volts DC
All measurements made with controls at center.
Noise measurements are A-weighted.
POWER
The Red Llama™ Overdrive is powered by a single 9-volt battery, a
9-volt AC adapter such as the Dunlop ECB003, or the DC Brick
™
and Iso-Brick
™
power supplies. The power input is a 5.5mm x 2.1mm
jack with the positive voltage on the outer sleeve. Using an external
power supply will disconnect the battery. Disconnect the input jack
to preserve battery life when not in use. The pedal will lock into
bypass mode when it is time to change the battery. It also includes
power protection circuitry to prevent damage from AC power
supplies.
92
50
30
16
58
6RE
VA
