NOTES
WayCon Positionsmesstechnik GmbH
Mehlbeerenstrasse 4
82024 Taufkirchen / Germany
This is to certify that the products
Classification
Linear potentiometer
Series
LZW2
fulfill the current request of the following EC-directives:
EMV-directive
2004/108/CE
applied harmonized standards:
EN 61000-6-2:2005, EN 61000-6-4:2007, EN 61326-1:2006
The declaration of conformity loses its validity if the product is misused or modified without proper
authorisation.
Taufkirchen, 13.03.2013
Andreas Täger
CEO
DECLARATION OF EC-CONFORMITY
All the data reported in this brochure and the data sheet, like linearity, lifetime, temperature coefficient are
valid for a sensor utilization as a ratiometric device with a max current across the cursor Ic ≤ 0.1 mA.
Do NOT use the linear transducer as variable resistance!
When calibrating the transducer, be careful to set the stroke so that the output does not drop below 1% or
rise above 99% of the voltage level.
MAINTENANCE
The sensors are maintenance free. It is not necessary to lubricate the moving parts.
INSTALLATION GUIDE
Linear Potentiometer Series LZW2
For further information please see the data sheet at www.waycon.biz/products/linear-potentiometers/
FIRST STEPS
ELECTRICAL CONNECTION
WayCon Positionsmesstechnik GmbH would like to thank you for the trust you have placed in us and our
products. This manual will make you familiar with the installation and operation of our linear
potentiometers. Please read this manual carefully before initial operation!
Unpacking and checking:
Carefully lift the device out of the box by grabbing the housing. After unpacking the device, check it for
any visible damage as a result of rough handling during the shipment. Check the delivery for
completeness.
If necessary consult the transportation company, or contact WayCon directly for further assistance.
3 brown (V+)
2 yellow (cursor)
1 blue (V-)
Sensor is to be used as voltage divider, using a
maximum cursor current of Ic ≤ 0.1 µA (do NOT use the
sensor as variable resistance!). Please pay attention to
the notes on the last page.
ACCESSORIES
Spare parts
STA075 bracket for LZW2-S
SND004 rod end bearing w ith M4 external
thread, housing side for LZW2-A
SND005 rod end bearing w ith M4 internal
thread, rod side for LZW2-A
PMX-24 Signal Conditioner
•
Converts potentiometer signals into analog output
signals: 4...20 mA, 0...10 V, 0...5 V, ±10 V, ±5 V
•
Input: potentiometer 1...20 kΩ
•
Configurable output
•
DIN-rail-mounting with face-side connector
•
For further information please
check the PMX-24 data sheet,
or contact WayCon
