FIRST STEPS
INSTALLATION GUIDE
Magnetostrictive Sensor Series MSB
For more information please see the data sheet at www.waycon.biz/products/magnetostrictive-transducers/
MOUNTING INSIDE A CYLINDER
WayCon Positionsmesstechnik GmbH would like to thank you for the trust you have placed in us and our
products. This manual will make you familiar with the installation and operation of our magnetostrictive
sensors. Please read this manual carefully before initial operation!
Unpacking and checking:
Carefully lift the device out of the box by grabbing the housing. After unpacking the device, check it for
any visible damage as a result of rough handling during the shipment. Check the delivery for
completeness. If necessary consult the transportation company, or contact WayCon directly.
The cylinder head (in which the threaded hole will be drilled for inserting the transducer) must be made of
non-magnetic material. The residual magnetization caused by drilling the threaded hole must be less than
4 Gauss.
MSB...F1
