please do not return this product to the store.
Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at
1-888-827-3667
for Consumer Assistance or online at
www.wayne-dalton.com
33
Maintenance
I
Monthly Maintenance:
1.
Lubricate hinges and rollers of garage door.
2.
Inspect the door for loose fasteners, worn or frayed counterbalance
cables and the presence of legible safety labels/ tags. Have repairs
made by a qualified service person. Contact customer assistance
for free replacement safety labels/ tags.
3.
With door fully closed, pull down on the emergency disconnect to
manually operate the door. If the door feels unbalanced or binds,
have a qualified service person make necessary adjustments or
repairs to the door.
4.
Perform the contact/obstruction tests. See Steps 24 and 25 for the
contact/obstruction test instructions. If door/opener fails contact/
obstruction test reset the door close limits according to the
instructions in Step 22, adjusting until door reverses on contact with
a 2 x 4 board laid flat on the garage floor. If opener still fails, have a
qualified service person make adjustments/repairs or this could
result in severe or fatal injury.
5.
Failure of door/opener to respond to transmitter or wireless keyless
entry may be due to a weak or dead battery. Press and hold the
activation button on either the transmitter or the wall station. If the
LED does not light, this is an indication that the battery is weak or
dead. Replace the battery.
twice a year:
Check chain tension. If chain rests on bottom of rail, adjust tension by
turning the two chain adjusting nuts at the end of the rails
(opposite the opener end) clockwise. Make sure to adjust both nuts
equal amounts and until chain is approximately 1/2” above the bottom
of rails when measured in the middle of the rails.
Battery replacement for transmitter:
Insert a coin in the coin slot of the transmitter and twist coin to access
the dead battery. Replace the batteries, being careful to match the
positive (+) symbols on the circuit boards with the battery; snap case
back together.
note:
Transmitters use two CR2016 or equivalent batteries.
note:
Dispose of dead batteries properly.
Battery replacement for wireless keyless entry:
To change batteries, snap open case with a coin and remove old
batteries. Replace the batteries, being careful to match the positive
(+) symbols on the circuit boards with the battery; snap case back
together.
note:
Keyless entries use two CR2032 or equivalent batteries.
note:
Dispose of dead batteries properly.
M
AINTENANCE
/ T
RO
uBLESHOOTING