11
Please Do Not Return This Product To The Store.
Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the
Find a Dealer
section online at
www.wayne-dalton.com
Tools Needed:
INST
All
ATION
Position the lower (numbered) leaf of the
#1 end hinge over the #1 and #4 holes in
the top of the end stiles, and secure to the
end stiles by 1/4”-14 x 5/8” self tapping
screws. Position and secure #1 center
hinge(s) with 1/4”-14 x 5/8” self tapping
screws using the pre-punched holes in
the top of the center stile(s).
NOTE:
The #1 hinges serve as end hinges
on the bottom section. The #1 hinges also
serve as center hinges at all center hinge
locations.
Insert roller into appropriate hinge tubes.
Repeat for all other sections using the #2
end hinges on the second (lock section)
and the #3 end hinges on the third section
(intermediate section).
NOTE:
#4 End hinges are used on fourth
section of five section doors.
IMPORTANT:
WhEN PLACING ROLLERS
INTO END hINGES #2 AND hIGhER, ThE
ROLLER GOES INTO ThE TuBE fuRThEST
AWAy fROM SECTION.
IMPORTANT:
ONCE fASTENER ARE
SNuG AGAINST hINGE LEAf, TIGhTEN AN
ADDITIONAL 1/4 TO 1/2 TuRN TO RECEIVE
MAXIMuM DESIGN hOLDING POWER.
hinges
END STILE hOLE
PATTERN
(LEfT SIDE IS ShOWN.
RIGhT SIDE IS
OPPOSITE.)
7
6
5
4
3
2
1
#1 hINGE
#2 END hINGE
#3 END hINGE
#4 END hINGE
CENTER STILE
hOLE PATTERN
ROLLER
PLACEMENT
ROLLER
PLACEMENT
ROLLER
PLACEMENT
hINGE
(2) 1/4”-14 X 5/8”
SELf TAPPING
SCREWS
CENTER STILE
(2) 1/4”-14 X 5/8”
SELf TAPPING
SCREWS
hINGE
END STILE
END hINGE PLACEMENT
CENTER hINGE PLACEMENT
#4 hOLE
#1 hOLE
Power Drill
7/16” Socket
Driver
5
