15
Please Do Not Return This Product To The Store.
Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the
Find a Dealer
section online at
www.wayne-dalton.com
Tools Needed:
Tools Needed:
INST
All
ATION
12
11
vertical Track
Stacking Sections
3/16” Drill Bit
Power Drill
7/16” Socket
Driver
Tape Measure
Level
Step Ladder
Power Drill
7/16” Socket
Driver
BOTTOM SECTION
5/16 X 2” hEX
hEAD LAG
SCREWS
fLAGANGLE
VERTICAL
TRACk
ASSEMBLy
jAMB
BRACkET
VERTICAL
TRACk
ROLLER
jAMB BRACkET
5/16” X 2”
hEX hEAD
LAG SCREW
fLAGANGLE hOLE
SELECTION
LOCk SECTION
NOTE:
for door section identification see
page 4.
NOTE:
Make sure hinges are flipped down,
when stacking another section on top.
Place rollers in hinge tubes of the second
section (lock section).
With assistance, lift the second section and
guide rollers into the vertical tracks.
Repeat for other section(s) except top
section.
Attach center hinge leaves to sections using
1/4”-14 x 5/8” self tapping screws. Repeat
for the upper hinge leaves.
IMPORTANT:
PuSh & hOLD ThE hINGE
LEAVES AGAINST SECTION WhILE SECuRING
hINGES.
NOTE:
Install lock at this time (sold
separately). See instructions in OPTIONAL
SIDE LOCk INSTALLATION on page 32.
IMPORTANT:
ThE TOPS Of ThE VERTICAL
TRACkS MuST BE LEVEL fROM SIDE TO SIDE.
If ThE BOTTOM SECTION WAS ShIMMED
TO LEVEL IT, ThE VERTICAL TRACk ON ThE
ShIMMED SIDE MuST BE RAISED ThE hEIGhT
Of ThE ShIM.
Position the left hand vertical track assembly
over the rollers of the bottom section. Make
sure the counterbalance cable is located
between the rollers and the door jamb. keep
track 5/8” from edge of door as shown in
illustration.
Drill 3/16” pilot holes for the lag screws.
Loosely fasten jamb brackets and flagangle to
the jamb using 5/16” x 2” lag screws.
On the bottom jamb bracket, tighten the lag
screw securing the bottom jamb bracket to
the jamb. Make sure the 5/8” track spacing is
maintained.
hang the cable drum over the flagangle.
Repeat for the right hand side.
5/8”
